INSTRUCTIONS FOR INSTALLATION AND USE SCAN DSA 4 Fireplace Insert SAVE THESE INSTRUCTIONS. 1
4.4 Masonry Fireplace Requirements • The chimney must have a clay tile liner or a stainless steel liner (positive connection). • Entire fireplace,
4.7 Factory-built, Zero –clearance Fireplace ( U.S. ONLY ) The Scan DSA 4 may be installed into a factory-built, prefabricated fireplace in the U.S
12 Surround Panel Installation Use the S-clips and provided with the Surround Panels. Both types of fasteners engage the surround to correspondin
13 5. OPERATION WARNING: DO NOT USE GASOLINE, LIGHTER FLUID, KEROSENE OR OTHER FLAMMABLE LIQUIDS TO START OR FRESHEN A FIRE IN THIS INSERT. KEEP AL
14 5.3 Starting a Fire: Do not elevate the fire. Build fire directly on the bottom of the firebox. To start a fire, pull the Start-up Air valve fu
6.3 Removing Baffle Cassette for Cleaning: Be sure that the fire is out and the fireplace is cold before removing the baffle cassette. The placem
16 4. Clean the area where the glass and gasket are to be installed. 5. Install the new flat self-adhesive gasket on the edge of the inside surfa
17 7.0 JØTUL N.A. WOOD-BURNING PRODUCT LIMITED WARRANTY Effective February 1, 2010 This warranty policy applies to wood-burning products identif
18 IN NO EVENT SHALL JØTUL, ITS PARENT COMPANY, SHAREHOLDERS, AFFILIATES, OFFICERS, EMPLOYEES, AGENTS OR REPRESENTATIVES BE LIABLE OR RESPONSIBLE T
19 8. TROUBLESHOOTING Smoke: • Insufficient chimney draught! • Check chimney height. Recommended height is minimum 15 feet. • Check if the chi
CONTENTS T1. IMPORTANT SAFETY NOTICE ...
Manufactured by Jøtul North America, Inc. 55 Hutcherson Dr. Gorham, Maine For Krog-Iversen&
3 Congratulations on your new SCAN DSA wood burning fireplace. We are confident that you will enjoy using your new SCAN DSA fireplace, however it i
4 2. CAUTIONS IF THIS FIREPLACE IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESLUT. FOR YOUR SAFETY FOLLOW THESE INSTALLATION INSTRUCTIONS. CONTAC
5 3. INTRODUCTION / INSTRUCTIONS FOR USE 3.1 About the SCAN DSA 4 fireplace SCAN DSA 4: CAUTION: Do not operate the fireplace with the start de
6 3.7 Ceramic gasket: The SCAN DSA 4 fireplace is equipped with ceramic gasket to ensure the door and glass are tightly sealed. This ceramic gas
4. INSTALLATION (Qualified technicians only) The Scan DSA 4 is approved for installation into a masonry fireplace that conforms to the requirements
NOTE: Allow extra room for installation, especially above the insert when using a direct or positive connection. 4.2 Fireplace placement requirement
4.3.1 Mantel Clearances 4.3.2 Hearth and floor protection requirements: • When the bottom of the fireplace is installed less than 3 1/2” (88 mm)
Comments to this Manuals