SCAN DSA 4 Service Manual

Congratulations on your new Scan insertYou have purchased a product by one of Europe’s leading manufacturer’s of wood-burning stoves, and we are sure

ASSEMBLY10Set the adjustment screws with an open-end spanner so the cassette is level.4 x Rawl plugs 10 x 504 x Washers Ø 8 / Ø 16 x 1.54 x Torx screw

11ASSEMBLYNB: If you have chosen to install your Scan DSA 11 with a fan, go to page 14 for installation of the fan. Then continue with the installatio

ASSEMBLY12Fit the gasket provided to the flue connection piece.GasketFit the flue connection piece in the flue outlet with 5 x Allen screws. If necess

13ASSEMBLYFit the smoke deflector plate and the door of the insert.

FITTING OF ACCESSORIES14Fitting the convection connection piecesCut through the fastening points in the cover plates for the convec-tion connection pi

FITTING OF ACCESSORIES 15Cable relief and screws for bracketRegulator ES 904 Cable for connection bet-ween ES 904 and fanFitting the fanThe Installati

FITTING OF ACCESSORIES16Cable with male connector for fan.Remove the bracket from the male connector.Fit the bracket onto the cassette with the two su

17FITTING OF ACCESSORIES21N312N3BRWHBLBRWHBLMotorBLWHBRN48576123PENLES904Connection table for fanConductorCable colourLNPELine (phase)NeutralProtectio

INSTRUCTION FOR USE18CB Technology (Clean Burning)The stove is equipped with the clean burning technique. In order to ensure an optimal combustion of

INSTRUCTIONS FOR HEATING19Environmentally-Friendly HeatingAvoid restricting your wood-burning stove to an extent where no flames are visible during th

2 CONTENTSTable of contentsTechnical data……………………………………………...……………………….. 3 Installation Certifi cate of testing Technical dimensions and da

INSTRUCTIONS FOR HEATING20General NotesYour wood stove is not designed for continual heating for periods of over 24 hours.Please note! Parts of the wo

MAINTENANCE21Maintaining your wood-burning stoveApart from regular chimney sweeping, your wood-burning stove does not require any regular maintenance.

TROUBLESHOOTING22Smoke escaping • Damp wood • Chimney not drawing properly • Chimney is not properly dimensioned for the stove • Check if the sm

Scan A/S - DK-5492 VissenbjergVersionGB 90084500-508.02.2010

3InstallationThe house owner is responsible for ensuring that all necessary natio-nal and local safety measures are observed during installation and f

4 TECHNICAL DATA656730166420590640468794143113Dimensioned drawing for Scan DSA 11

5Product registration numberTake the insert out of the cassette and read the product registration number and make a note of it below. This number must

6 ASSEMBLYBBTo remove the door:Loosen the Pointed screw, remove the rivet and lift the door off.Pointed screwRivetRemoving the packagingScan DSA 11 is

7A-AB-BC-CAABBCC3001001005034050300Distance to furniture: 1500 mmBut please check to avoid furniture or other furnishings being dried out due to bein

8 ASSEMBLYFloor plateThe national and local building regulations must be followed regar-ding the size of a non-flammable base which is to cover the fl

9ASSEMBLYD6 x clipsFit the clips. They will be used later for securing the trim.To secure the cassette, pre-drill the 4 holes with a 10 mm drill bit.P