SCAN 61 User's Guide download pdf (Page 21)

Chapter 1 — Introducing the SR61B Cordless Scanner

SR61B Cordless Scanner User’s Guide 9

If you are using bar code labels that are encoded in a different

symbology, you need to enable the symbology on your SR61B. Use

EasySet version 5.6.5.3 or later to enable and disable symbologies for

your scanner. EasySet is available on the Intermec web site at

www.intermec.com.

Before you can scan bar codes and send data to your data collection

application, you need to establish a Bluetooth connection between

your SR61B and the host device. If your scanner is not connected it

will emit an error beep when scanning bar codes. For more

information about establishing a Bluetooth connection, see

“Connecting the SR61B” on page 17.

To scan a bar code label with an SR61BL or SR61B1D

1 Turn on your scanner by pressing the trigger.

2 Connect your scanner to a Bluetooth device.

3 Point the SR61B at the bar code label and hold the SR61B at a

slight angle 5 to 10 cm (2 to 4 in) from the label.

4 Pull the trigger, and direct the red beam so that it falls across all

bars in the bar code label.

Use this test bar code:

Code 39 Test Bar Code

*123456*

Tip: Depending on your screen resolution, you may be able to scan

bar codes displayed on your computer screen except with SR61BL

(laser imager). Print out and scan bar codes with the SR61BL.

When the SR61B successfully reads a bar code label, the SR61B

beeps one time, the status light briefly turns green, and the

scanner beam turns off. If Vibrate Alert is enabled, the SR61B

briefly vibrates.

5 Release the trigger.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 77 78

No comments

SCAN 61 User's Guide Page 21