SCAN 61 User's Guide download pdf (Page 65)

Chapter 4 — Troubleshooting and Maintaining the SR61B

SR61B Cordless Scanner User’s Guide 53

To clean the scanner window

1 Dip a clean towel or rag in soapy water, ammonia and water

solution, or isopropyl alcohol and wring out the excess. Wipe the

scanner window. Do not allow any abrasive material to touch the

window.

2 Wipe dry with a lint-free cloth.

Recovering the SR61B

The following procedures describe how to reset your scanner when it

is unresponsive and how to rescue it if you inadvertently set it up in a

configuration that prevents any extra configuration.

Resetting the SR61B

If your SR61B does not respond when you pull the trigger, you can

reset it. When you reset your SR61B, the scanner control firmware is

restarted.

To reset your SR61B

• Remove and install again the battery from the SR61B.

If you have a Bluetooth connection, the SR61B disconnects from the

host device. After a reset, the SR61B tries to reestablish a Bluetooth

connection with the host device when you turn it on.

Rescuing the SR61B

If you cannot configure your SR61B anymore because it is in a locking

configuration (for example, if you inadvertently disabled the trigger),

you can rescue it. When you rescue your scanner, factory default

settings are restored including custom default settings.

To rescue your SR61B

1 Reset your scanner by removing and installing again the battery.

2 Pull the trigger for 10 seconds approximately, until the red LED

lights up.

3 Release the trigger then press it rapidly five times while the red

LED is on (2 seconds).

The green LED stays on while the scanner beeps as a confirmation

(six-beep melody), then the scanner powers off.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 77 78

No comments

SCAN 61 User's Guide Page 65